Jocel JFE014641 Instruction Manual page 93

3. TIMER FUNCTION MODE SWITCHING
Long press program button "M" for 3s enter to system time setting status, without
any operation after 5S, system time, oven in use symbol " " and decimal point
symbol " " keep bright display; you can circularly switch the oven timer function
mode by program button "M".
The operation flow and corresponding functional sequence are as followings:
Timer function mode switching diagram
4. OPERATION INSTRUCTIONS
4.1 POWER ON
For the first time, the buzzer "beep" for one time to show that the timer enters into
the standby state. The clock shows the time of the system and starts the timing.
Power-on displays as "0·00", the display screen displays the system time, the
decimal point symbol " " is flashing,1 second 1 time, like Pic 5. You can
push" "to choose 3 kinds of ring tone, The default is the second ring tone.
Whenever user wants to adjust the ring tone again, press " ".
Pic 5 Power-on default clock diagram (standby state)
4.2 START UP AND TIME SETTING
When the display is flashing, press " "for 3 seconds to start up the oven. Then
oven in use symbol " "lights up and decimal point symbol " " twinkles. When
decimal point symbol " " twinkles, press " "or " " to set the system time.
After choosing the time, lift the finger off the buttons and wait for 5 seconds, then
decimal point symbol " " stop twinkling. It means time is well set. Like pic
8.Whenever user wants to set the time again, In the status of pic 7, push " "
one time, when user sees decimal point symbol " " twinkles, then can set the
time again.
93