Jocel JFE014641 Instruction Manual page 82

• Danger of electric shock! Do not attempt to repair the appliance yourself. In
case of malfunction, repairs are to be conducted by qualified personnel only.
• To avoid damaging the cord, do not squeeze, bend or chafe it on sharp edges.
Keep it away from hot surfaces and open flames as well.
• Lay out the cord in such a way that no unintentional pulling or tripping over it
is possible.
• Do not open the appliance casing under any circumstances. Do not insert
any foreign objects into the inside of the casing.
• Never use accessories which are not recommended by the manufacturer.
They could pose a safety risk to the user and might damage the appliance.
Only use original parts and accessories.
• Keep the appliance away from any hot surfaces and open flames. Always
operate the appliance on a level, stable, clean and dry surface. Protect the
appliance against heat, dust, direct sunlight, moisture, dripping and splashing
water.
• Do not place objects with open flames, e.g. candles, on top of or beside the
appliance.
• WARNING: Ensure that the appliance is switched off before replacing the
lamp to avoid the possibility of electric shock.
• The fixed wiring for applicant shall have an all-pole disconnection device.
SAFETY:
• Attention, the glass is extremely fragile. Always wear gloves when handling.
• For your safety, this product is made of tempered glass. This type of glass is
highly resistant but has the feature to retain the "memory" of shocks.
• Therefore, it should handle the product with the greatest care to avoid shocks
and twists, especially during installation.
• Avoid installing this type of product in areas where it would be highly exposed
to shocks.
• Do not let children play with the product.
• Do not stick adhesive film on the glass surface. In case of breakage, it would
generate large pieces that could be dangerous
ELECTRICAL CONNECTION
DANGER OF ELECTRIC SHOCK!
• Any electrical installation must be carried out by an authorized professional.
• All fittings must be installed by a competent person in accordance with local
regulations. If in doubt, consult a qualified electrician.
• Important! Always switch off the electricity supply at the mains during
installation and maintenance. We recommend that the circuit breaker
switched off at the distribution board whilst work is in progress.
82