Advertisement
SECTION 1 |
1.1 SAFETY SYMBOLS
The following safety symbols will be used in this manual to highlight safety
and information:
WARNING!
Indicates possibility of physical harm to the user in case of non-compliance.
!
CAUTION!
Indicates possibility of damage to the equipment in case of non-compliance.
i
INFO
Indicates useful supplemental information.
Please read these instructions before installing or operating the unit to prevent personal
injury or damage to the unit.
1.2 SAFETY INSTRUCTIONS - GENERAL
1.2.1 Installation and wiring compliance
• Installation and wiring must comply with the Local and National Electrical Codes and
must be done by a certified electrician.
1.2.2 Preventing electrical shock
• Always connect the grounding connection on the unit to the appropriate grounding
system.
• Disassembly / repair should be carried out by qualified personnel only.
• Disconnect all AC and DC side connections before working on any circuits associated
with the unit. Turning the ON/OFF switch on the unit to OFF position may not entirely
remove dangerous voltages.
• Be careful when touching bare terminals of capacitors. Capacitors may retain high le-
thal voltages even after the power has been removed. Discharge the capacitors before
working on the circuits.
1.2.3 Installation environment
• The inverter should be installed indoor only in a well ventilated, cool, dry
environment.
• Do not expose to moisture, rain, snow or liquids of any type.
• To reduce the risk of overheating and fire, do not obstruct the suction and discharge
openings of the cooling fan.
• To ensure proper ventilation, do not install in a low clearance compartment.
1.2.4 Preventing fire and explosion hazards
• Working with the unit may produce arcs or sparks. Thus, the unit should not be used
in areas where there are flammable materials or gases requiring ignition protected
Safety Instructions
SAMLEX AMERICA INC. | 3
Advertisement
