4.4
System setup via the Ethernet interface
Note
Power supply using "Power over Ethernet" (PoE)
If the optical reader is supplied by PoE, for example when connected to a
SCALANCE X108POE, the Power IO RS232 cable is not needed.
①
②
Figure 4-3
System characteristics
● The result output of the optical reader takes place via the Ethernet interface.
● The optical reader can be triggered via either:
– Digital I/O
– TCP/IP
– The built-in auto-trigger function
● A PC/programming device is connected via Ethernet for the adjustment procedure.
SIMATIC MV500
Operating Instructions, 05/2019, C79000-G8976-C494-02
Optical sensor or light barrier (for trigger signal)
Object with code
Example: System configuration via the Ethernet interface
Network and system integration
4.4 System setup via the Ethernet interface
57