Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
TIPS & INFORMATION
IMPORTANT
Before the installation, note down the serial number
from the rating plate. The rating plate of the appliance is
on its lower casing.
WARNING
WARNING
You must read these!
•
Make sure that the appliance has not been damaged
in transportation. Do not connect a damaged
appliance.
If it is necessary, speak to the supplier.
•
Only an authorized servicing technician can install,
connect or repair this appliance. Use only original
spare parts.
•
Only use the built-in appliances after you assemble
the appliance into correct built-in units and work
surfaces that align to the standards.
•
Do not change the specification of this appliance.
Due to a risk of injury and damage.
•
Fully obey the laws, ordinances, directives and
standards in the country where you use the appliance
(safety regulations, recycling regulations, electrical
safety rules etc).
•
Keep the minimum distances to other appliances and
units.
•
Make sure that the ventilation space of 5mm, under
the benchtop and directly in front of the appliance is
free. The warranty does not cover damages caused
by lack of adequate ventilation.
•
Install shock protection, for example install the
drawers only with a protective floor directly below
the appliance.
•
Do not use an external timer or a separate remote-
control system to operate the appliance.
•
Set the cooking zone to "off" after each use. Do not
rely on the pan detector.
•
Keep the cut surfaces of the worktop safe from
moisture with a correct sealant.
•
Seal the appliance to the worktop with no space
between with a correct sealant.
•
Keep the bottom of the appliance safe from steam
and moisture, e.g. from a dishwasher or oven.
•
Do not install the appliance adjacent to doors and
below windows, due to risk of cookware being
pushed off hot appliance.
4
INSTALLATION
WARNING
WARNING
Risk of injury from electrical current. Carefully obey the
instructions for electrical connections.
•
Make electrical mains terminal free of voltage.
•
Install correctly to give shock protection.
•
Loose and incorrect plug and socket connections can
make the terminal become too hot.
•
A qualified electrician must install the connections in
the clamps correctly.
•
Use a strain relief clamp on cable.
•
Use the correct mains cable of type H05BB-F Tmax
90°C (or higher) for a single phase or two phase
connection.
•
Replace the damaged mains cable with a special
cable (type H05BB-F Tmax 90°C; or higher). Speak
to our Customer Care team.
The appliance must have the electrical installation which
lets you disconnect the appliance from the mains at all
poles with a contact opening width of minimum 3mm.
You must have correct devices to isolate: line protecting
cut-outs, fuses (screw type fuses removed from the
holder), earth leakage trips and contactors.
Advertisement
Table of Contents
