Cómo Colgar El Ventilador - Hinkley UNA 56 Instruction Manual

CÓMO COLGAR EL VENTILADOR
Remove ball from downrod by loosening set screw in the
1
side of the ball. Slide ball down and remove cross pin;
remove ball. (Fig. 1)
Carefully support fan body (motor) in its styrofoam packing
2
with the mounting collar (where the wires come out) facing
upward.
Loosen the two security set screws and remove the downrod
3
pin and cotter clip from the coupling on top of the motor
assembly. (Fig. 2)
Carefully feed the electrical lead wires and safety cable from
4
the fan through the downrod. Thread downrod into coupler
until holes align. Insert downrod pin through holes in
mounting collar and downrod; clip cotter pin through small
hole in end of downrod pin to hold downrod in place.
Tighten security set screws against downrod using a large
5
flat blade screwdriver to ensure a tight fit against downrod.
06 | hinkley.com
Pasador cruzado
Bola de
suspensión
Tornillo de ajuste
Fig. 1
Cables de conexión (3)
varilla
Tornillos de seguridad
Collarín de montaje
pasador de chaveta
Parte
superior del
cuerpo del
ventilador
Fig. 2
varilla
cable de seguridad
Pasador de
varilla