Advertisement
Quick Reference Guide of WebEye B106
When you connect cable to terminal block, you should peel off the cov er of cable by 1.5Cm
and insert the cable by 2Cm into the terminal block.(communication., sensor, alarm and etc) In
case of power cable, the white mark of two lines means '+'.
2.2 Connect WebEye and a PC with Network Cable.
l To connect WebEye on Internet or LAN. With this connection remote user may not
access WebEye before local user configure its network setting.
Internet
Router
l To directly connect WebEye to a PC, use the red crossover cable. This connection is just
to configure WebEye.
Note in connecting cable to terminal block
0.5cm
Covered
Total length to insert in Term inal Block = 2cm
Dedicated line, xDSL line, cable
modem line, ISDN line, and PSTN
(telephone) line are available
Direct cable
Connect WebEye to a
PC through a HUB
Connect WebEye directly to
a PC through LAN ports.
1.5cm
Peeled
.
HUB
Crossover cable
4
Remote User
Local User
Advertisement
