Advertisement
Quick Reference Guide of WebEye B106
5. Go to 'Gateway'.
6. Check gateway address.
1.4 Internet Browser Requirements
l Internet Explorer 5.0 and above
l Netscape Navigator 4.7 and above
1.5 Check LAN
l The WebEye should be connected to a 10 Base-T LAN. 10 Base-T LAN is standard for
network configuration.
l In the rare instance of 100 Base-T LAN, a 10/100 switching hub will be needed to
convert 100 Base T to 10 Base T.
2. Connecting Ethernet and Power Cables to WebEye.
2.1 Connect network and power to WebEye
l Make sure that indicator lights and dipswitches are as follows:
6. After receiving power, yellow
LED should go on for 5-6 seconds
and then go off. This LED starts to
blink when user accesses WebEye.
3. Connect LAN
cable (RJ-45).
2. Check DIP switch. Selected channel
switch is up, Not connected channel is
down.
5. The green LED should blink
every 1-2 second(s) 1-2 seconds
after receiving power.
7. Go to 'IP Address'
8.
Check
IP
address and subnet
mask.
1. Connect external camera as
you want channel.
3
4. The power input
jack. Use the included
12-volt power adapter.
Advertisement
