Automatic Code Search; Know The Mode - RCA Scenium DRS720N User Manual

Notes:This remote may not be compatible with all brands and models of components.
It may also not operate all functions of the remote that came with your component.
If Direct Entry doesn't work try the Automatic Code Search below.

Automatic Code Search

The Automatic Code Search method tests all of the codes for a specific component button. If you
want to stop the automatic code search without programming any of your components, press
CLEAR until the indicator on the remote turns off.
1. Turn on the component you want to operate (TV, cable box or satellite receiver)
2. Press and hold the component button you want to program.While holding the component
button, press and hold the ON•OFF button until the indicator light on the remote turns on—
then release both buttons.
3. Point the remote at the component. Press and release PLAY, then wait 5 seconds or until the
indicator on the remote stops flashing.
At this point the remote is searching for the correct code to program (you'll know it's found
the correct code when the component turns off, go to step 4). If, after 5 seconds, it doesn't
turn off, press PLAY again to tell the remote to search the next set of codes.
Continue pressing PLAY until the component turns off or you have searched through all of
the codes.When the indicator light turns off, and stays off, the remote has searched all of the
codes- which means this remote can't be programmed to operate your TV, satellite receiver,
or cable box.You'll have to use the remote that came with it.
4. When the component turns off, the remote has found the proper code. Press and release
REVERSE, then wait 2 seconds. Repeat this step until the component turns back ON.
5. To finish, press and hold STOP until the indicator on the remote turns off.The code is now
saved.

Know the Mode

Once you've programmed the remote to operate other components, you need a basic
understanding of how the remote control works.The codes in the remote control that make a
component act a specific way are mode dependent— if you want to turn on or off a component,
you must press the TV button before you press the ON•OFF button so the remote control
knows that you want to access the TV.
To summarize, to operate the DVD player you must press the DVD button; to operate the TV, you
must press the TV button; to operate a satellite receiver or cable box, you must press the
SAT•CABLE button. Once the remote is in a mode, it stays in that mode until you press a
different component button.
The Remote Control
13