Table of Contents
Advertisement
The Remote Control
DVD
ON
•
OF F
SAT• C A B LE
TV
RETU R N
CH
VOL
MUTE
G O• B A C K
CLEAR
MEN U
OPEN• CLOSE
ANGLE
ZO OM
GUIDE
INFO
1
2
3
4
6
5
7
8
9
INPUT
ANTEN NA
0
REVERSE
PLAY
FORWAR D
RECOR D
STOP
PAUSE
AGAIN
LIVE
ADVANCE
REVERSE button
Can the remote operate your
ON•OFF button
component
TV button
This remote control is designed to operate most RCA,
SAT•CABLE
GE, and Proscan products.
Indicator light
1. Press the component mode button you want to
CLEAR button
2. Point the remote at the component. Press the
3. If that doesn't work, you can try programming the
Programming the remote
The universal remote can be programmed to operate
PLAY button
most brands of remote controllable components.There
are two ways to program this remote: Direct Entry and
Automatic Code Search (both methods are described
below).
Note:The DVD button can't be programmed on this remote.
STOP button
Direct Entry
1. Turn on the component to be programmed (TV or
2. Look up the brand and code number(s) from the list
3. Press and hold the component button you want to
4. Enter the 4-digit code from the code list for your
5. Release the component button.
6. Point the remote toward the component and press
•
•
operate (TV or SAT•CABLE)
ON•OFF button (if the component turns on or off,
this remote will operate it).
remote by following the instructions below.
SAT•CABLE)
starting on page 14.
program on the remote (TV or SAT•CABLE)
brand (pages 14-17).
the ON•OFF button to see if it responds to the
command. If it doesn't try pressing the component
button and then ON•OFF again.
If you get no response, repeat these steps using the
next code listed for your brand, until the component
responds to the remote commands.
If you try all the codes for your component brand and
none work, try the automatic code search method. If
automatic code search doesn't find the code, the
remote is not compatible with your component.
12
Continued on next page
Advertisement
Table of Contents
