Speaker
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
From the outside, front of the chassis, remove the two Torx T15 screws that secure the speaker to the
chassis.
5.
Disconnect the speaker wire from the system board connector labeled INT_SPKR (1).
6.
Remove the speaker from the chassis (2).
To replace the speaker, reverse the removal procedures.
38
Chapter 4 Removal and replacement procedures – Microtower (MT) chassis
(Preparation for disassembly on page
(Access panel on page
15).
(Front bezel on page
16).
14).