Table of Contents
Advertisement
3. Install optional stroke control kit (16) to cylinder
rod. Stroke control kit is used to set cut height.
Install SMV Emblem
1. Remove manual tube and hardware.
2. Align holes of manual tube and SMV mounting
bracket (17) and reattach to deck using previous
hardware.
1. Tailwheel arm
2. Tire & hub
3. Attitude rod
5. Transport lock-up
6. 3-1/2 x 8 Hydraulic cylinder
7. 1/2 to 1/4 Reducer
8. Elbow with restricter
9. Hose
10. Ratchet adjustment link
11. Spring arm
12. Spring
13. 1 x 2.72 Headless pin
14. 1 x 4-1/2 Headless pin
15. 1 x 5 Headless pin
16. Stroke control kit
17. SMV Mounting bracket
Figure 28. DS1260 & DS1440 Pull-Type Cutter Assembly - Rear Half
(Rev. 7/16/2012)
MAN0571 (Rev. 6/15/2007)
3. Attach SMV socket (18) with two carriage bolts (29)
and lock nuts (30).
4. Attach SMV emblem (20) to SMV bracket (19)
using two round head cap screws (31) and hex
nuts (32).
5. Insert SMV bracket (19) and emblem (20) into
socket (18).
18. SMV Socket
19. SMV Bracket
20. SMV Emblem
21. 5/8 NC x 5 HHCS GR5
22. 5/8 NC Lock nut
23. 1/2 NC x 3 HHCS GR5
24. 1/2 NC Flanged lock nut
25. 1" Standard flat washer
26. 1" NC Hex nut
27. 1/4 x 1-1/2 Cotter pin
28. 1/2 NC x 5 HHCS GR5
29. 5/16 NC x 3/4 Carriage bolt
30. 5/16 NC Flanged lock nut
31. 1/4 NC x 1/2 Round head screw
32. 1/4 NC Nut
33. 1/2 NF Lug nut
Assembly 39
Advertisement
Table of Contents
