Table of Contents
Advertisement
Setting Radio Station Presets
To set preset radio stations, do the following:
1. Press the power/volume knob to turn
the system on.
2. Press the BAND hard key.
3. Select the desired band (AM, FM1, FM2,
XM1, or XM2 (if equipped)).
4. Seek, scan, or tune to the desired stations
using the seek and scan hard key arrows or
the tuning knob.
5. Press and hold one of the six preset screen
buttons, at the bottom of the screen, until you
hear a beep or see the station displayed
on the selected preset button.
6. Repeat the steps for each preset.
See "Preset Stations" under Navigation Audio
System on page 92 for more information.
Setting the Time
To set the time, do the following:
1. Press the power/volume knob to turn the
system on.
2. Press the CONFIG hard key.
H
3. Press the
(clock) screen button.
4. Select the 12hour or 24hour screen button to
display the time in standard or military time.
5. Select the AM or PM screen buttons.
6. Select the appropriate time zone screen
button.
7. Select the Daylight Saving Time screen
button, if necessary.
8. Press and hold the hour and minute arrow
buttons to increase or to decrease the time
or press the GPS TIME screen button to reset
radio time to GPS time.
The radio will use the GPS satellite to set the
time. The vehicle needs to be in an open area to
receive the signal. See "Clock" under Configure
Menu on page 75 for more information.
9
Advertisement
Table of Contents
