4 SENSOR POSITIONING FOR INSTALLATION
This section describes the WEGscan 100 mechanical installation on electric motors with emphasis on the
central position of the motor. For installation on other assets and in other positions on the motor, see Chapter
4.4 and 5.
4.1 SENSOR POSITIONING – APPLICATION: WEG ELECTRIC MOTOR OF THE W22 AND
W50 LINES
According to the representation in the Figures 4.1 and 4.2, the sensor must be installed approximately in the
center of the motor and at a distance M from the top of the fin. Distance M varies according to the motor
frame and line and is indicated in Table 4.1.
16 mm
Figure 4.1: Sensor fixed on W22 motor
Figure 4.2: Sensor fixed on W50 motor
|
WEGscan 100
4-1