Posicionamento Do Sensor - Aplicação: Ativo Motor Elétrico Weg Da Linha W40 - WEG WEGscan 100 Mechanical Installation Manual

4.2 POSICIONAMENTO DO SENSOR – APLICAÇÃO: ATIVO MOTOR ELÉTRICO WEG DA
LINHA W40
The sensor can be installed on motors of the W40 line following the positions shown in Figure 4.3 (for frames
IEC 160 to 280S/M, if the terminal box is on top, place the sensor on the side base as shown in Figure 4.3a; if
the terminal box is on the side, place the sensor on top as shown in Figure 4.3b). In the case of the top box,
if there is any component on one of the side bases, it must be fixed on the opposite base.
(a) Top box
Figure 4.3: WEGscan fastening location for motors of the W40 line, frames IEC160 to 280S/M
(a) Frame 280L
Figure 4.4: WEGscan fastening location for motors of the W40 line, frames 280L and above
For frames 315 and above, check the values of the distance between the hole and the center in Table 4.2.
Table 4.2: Distances between the hole and the center of the motor
L
L
125 mm
Frame
315 (5010/11)
355 (L5010/11)
400 (L5809/10 e L5810/11)
450 (L6808/09)
Sensor positioning for installation
(b) Side box
(b) Frames 315 and above
Distance (mm)
250
290
320
340
D
|
WEGscan 100 4-3
4