Sensor Positioning - Application: Weg Electric Motor Of The W60 Line - WEG WEGscan 100 Mechanical Installation Manual

Sensor positioning for installation
4.3 SENSOR POSITIONING – APPLICATION: WEG ELECTRIC MOTOR OF THE W60 LINE
Due to the design of W60 motors, it is recommended to mount the WEGscan on the side base (Figure 4.5).
The WEGscan must be positioned at the shaft center height, centered in the motor length. If the terminal box
occupies the indicated region, place the WEGscan on the opposite side to the connection box. The sensor
4
can be positioned with an offset of up to 40 mm in the axial direction, and up to 20 mm in the transverse to
the axial direction in relation to the recommended position.
Figure 4.5: Detail of the position for mounting the WEGscan system device on W60 motors
|
4-4 WEGscan 100