3.3 SENSOR DIRECTLY MOUNTED WITH ADHESIVE
For the correct installation of the sensor on the asset, directly with adhesive, the tools and materials shown
in Figure 3.3 are required.
(a) WEGscan 100
Figure 3.3: Materials required to install the sensor directly with adhesive
3.4 SENSOR MOUNTED WITH ADHESIVE AND INTERMEDIATE SUPPORT
For the correct installation of the sensor on the asset, with adhesive and intermediate support, the tools and
materials shown in Figure 3.4 are required.
(a) WEGscan 100
(d) Allen wrench 3 mm
Figure 3.4: Tools and materials needed to install the sensor with adhesive and intermediate base
(b) Fine sandpaper for steel
(b) M4x40 mm screw
(e) Fine sandpaper for steel
Tools and materials for installation
(c) Two-component epoxy adhesive
(c) Intermediate base
(f) Two-component epoxy adhesive
WEGscan 100
3
|
3-3