Mitsubishi MELSEC-Q Q Series User Manual page 73

5 UTILITY PACKAGE (GX Configurator-AD)
[Explanation of items]
(1) Contents of screen display
(2) Explanation of the command buttons
The following describes an example where sampling process for the selection test
operation is changed to a 10-time averaging process setting.
(1) Set averaging process in the setting value field for CH
(2) Set number of times in the setting value field for CH
(3) Click the setting value field for CH
(4) After entering the average number of times, press the Enter key.
(5) Select the setting value fields that were specified in steps 1 to 4 while holding
(6) Click Execute test to execute write operation.
5 - 17
All manuals and user guides at all-guides.com
Setting item : The I/O signal or buffer memory names are displayed.
Current value : The I/O signal status or current value of buffer memory are
monitored.
Setting value : Select or enter the data to be written during test operation.
Current value display
Make text file
Start monitor /
Stop monitor
Execute test
Close
REMARK
process/Averaging process setting.
specifying.
setting to select.
At this point, nothing has been written to the A/D converter module.
down the Ctrl key.
Once writing has been completed, the value that was written will be displayed in
the present value field.
The current value of the selected item is displayed.
(This is used to check text that cannot be displayed in
the current value field. However, in this utility package,
all items can be displayed in the display fields).
Creates a file consisting of the screen contents in text file
format.
Selects whether or not the current value fields are
monitored.
Performs a test of the selected item. To select more
than one item, select multiple items while holding down
the Ctrl key.
Closes the screen currently displayed and returns to
the previously displayed screen.
Average time/average number of times
MELSEC-Q
Sampling
Time/number of times
5 - 17