Cut In Pressure Setting; Cut Out Pressure Setting; Basic Menu - Xylem Bell & Gossett GF60 Instruction Manual

4.2.2 Cut in pressure setting

1. Press
2. Cut in pressure value is displayed on the screen and the START LED turns on and
flashes.
3. Set the adjusted rated current by pressing
4. Press
Factory set to 12 psi

4.2.3 Cut out pressure setting

1. Press
2. Cut out pressure value is displayed on screen, and the STOP LED turns on and flashes.
3. Set the adjusted rated current by pressing the
4. Press
Factory set to 20 psi

4.2.4 Basic menu

BASIC MENU
• Press at the same time
• The values can be changed by pressing
• Press
• The parameter sequence is:
GF60 INSTRUCTION MANUAL
for three seconds.
for validation.
for three seconds.
for validation.
+ (diagram C)
+
for validation.
it
1 Bar
2 rc0
and buttons.
and
buttons for five seconds.
or .
Type System Reaction
P We can select the
pressure units that
are displayed
between bar and
psi.
rc2 Fast-cycling alarm:
– rc0: alarm
unabled.
– rc1: activated,
when
hammering is
detected it
delays start to
protect the
pump.
– rc2: alarm is
activated and
the pump is
stopped upon
detection.
4 Operation
buttons.
Factory Setting
bar
rc0
11