1. Manuals
  2. Brands
  3. Samson Manuals
  4. Microphone system
  5. CB88
  6. Quick start manual

Samson CB88 Quick Start Manual

Single system setup
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
7. Install batteries
Quick Start - Single System Setup
With the transmitter powered off, install two fresh AA batteries into the CB88 belt
pack or CH88 handheld transmitter. Leave the battery compartment open.
8. Press button on transmitter to turn on
9. Press and
7. Install batteries
Turn on the power to the transmitter by pressing and holding Power switch; the indi-
7. Install batteries
8. Press button on transmitter to turn on
cator LED will light green.
8. Turn on belt pack transmitter
8. Press button on transmitter to turn on
7. Install batteries
9. Press and hold SELECT button to
8. Turn on belt pack tran
14

Advertisement

Table of Contents
loading

Related Manuals for Samson CB88

Summary of Contents for Samson CB88

  • Page 1 7. Install batteries Quick Start - Single System Setup With the transmitter powered off, install two fresh AA batteries into the CB88 belt pack or CH88 handheld transmitter. Leave the battery compartment open. 8. Press button on transmitter to turn on 9.

  • Page 2: Quick Start - Single System Setup

    Quick Start - Single System Setup Press the SELECT button on the front of the CR88 receiver to choose an available channel. The channel number will increase by one digit, from 0-9 then A-F. Once the last channel has been reached, the count will This device complies with Part 15 of the FCC Rules.
  • Page 3 Quick Start - Single System Setup When the transmission is complete, the CR88 will receive RF signal and the tone key from the transmit- ter. The READY indicator will light on the front panel of the CR88 receiver. Turn on your connected amplifier or mixer, but keep the volume all the way down.

  • Page 4: Quick Start - Multiple System Setup

    Quick Start - Multiple System Setup When using multiple systems, each system must be set to a different operating channel. Transmitter and receiver pairs must be on the same channel plan in order to work together (See "Concert 88 Channel Plans" on page 20). 8.
  • Page 5 Quick Start - Multiple System Setup Position the transmitter about 6-12" (15-30 cm) from the front of the CR88 with the transmitter's IR window facing the receiver's IR transmitter. 3. Plug in receiver 4. Turn on receiver 5. Pl 3. Plug in receiver 4.

  • Page 6: Rack Mounting

    Rack Mounting The CR88 receiver can be installed into a standard 19” rack for transport or per- manent installation using the included rack ears. Follow the simple steps below to mount the CR88: Attach the included rack ears by sliding each rack ear into the groove on either side of the CR88 until they lock into place, and the receiver flush with the front panel.

  • Page 7: Concert 88 Channel Plans

    556.075 620.075 654.975 558.975 622.975 655.975 559.975 623.975 657.050 561.050 625.050 658.975 562.975 626.975 660.425 564.425 628.425 661.975 565.975 629.975 * Not for use in the USA. For questions regarding available channels in your area contact your local Samson distributor.

  • Page 8: Troubleshooting

    Distorted Audio Check the transmitters batteries, and replace if low. The input gain on the transmitter (CB88) or audio source level may be too high. The transmitter may be too far away from the receiver. Move it closer to the receiver, or reposition the antennas.

  • Page 9: Specifications

    Operating Voltage 15 VDC 200mA Dimensions (LxWxH) 8.25" x 4.9" x 1.75" 210mm x 125mm x 44mm Weight 0.85 lb / 388 g At Samson, we are continually improving our products, therefore specifications and images are subject to change without notice.
  • Page 10 FCC Rules and Regulations Samson wireless receivers are certified under FCC Rules part 15 and trans- mitters are certified under FCC Rules part 74. Licensing of Samson equipment is the user’s responsibility and licensability depends on the user’s classification, application and frequency selected.
  • Page 11 Samson Technologies 45 Gilpin Avenue Hauppauge, New York 11788-8816 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 631-784-2201 www.samsontech.com...

This manual is also suitable for:

Ch88

Table of Contents