Quick Start - Single System Setup - Samson CB88 Quick Start Manual

Quick Start - Single System Setup

Press the SELECT button on the front of the CR88
receiver to choose an available channel. The channel
number will increase by one digit, from 0-9 then A-F.
Once the last channel has been reached, the count will
cycle back to 0.
Position the transmitter about 6-12" (15-30 cm) from the front of the CR88 with
the transmitter's IR window facing the IR transmitter on the front panel of the CR88
receiver.
3. Plug in receiver
Concert 88 Wireless System
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
FREQ:
(2) this device must accept any
542-566MHz interference received, including
interference that may cause
undesired operation.
Press and hold the CR88 SELECT button to set the
3. Plug in receiver
transmitter to the same channel as the receiver via
infrared transmission
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
FREQ:
(2) this device must accept any
542-566MHz interference received, including
interference that may cause
undesired operation.
4. Turn on receiver
10. Adjust Volume control
4. Turn on receiver
5. Plug r
15