Figure 14 Setup Window
SDLT 600A Product Manual
•
Save all changes
•
Restore all previous values
information.
Use DHCP
Check this box to enable DHCP.
If enabled, the SDLT 600A attempts to get its network configuration from
a DHCP server when it boots. If the device fails to connect to the network,
the predefined default values are used.
Hostname
Enter a name for the tape drive (the default is
user friendly name. This appears as part of the IQN and will also be
Chapter 2 Installing Your Tape Drive
— saves any setup modification information.
— restores the previous setup
Managing the Tape Drive
IP address
NTP server
). This can be a
SDLT600A
p
2
2
19