Axis 0942-001 User Manual page 67

AXIS Q6055-C PTZ Network Camera
Technical specifications
11 Braided shield coil
Function
Configurable (Input
or Output)
RX+
RX-
TX+
TX-
0 V DC (-)
DC output (24 V)
Media converter switch connectors
NOTICE NO NO TICE TICE
The product shall be connected using a shielded network cable (STP) or an optical fiber cable. All cables connecting the
product to the network shall be intended for their specific use. Make sure that the network devices are installed in
accordance with the manufacturer's instructions. For information about regulatory requirements, see Electromagnetic
compatibility (EMC) on page 2 .
Important
The media converter switch does not support hotswapping. Disconnect power from the switch before swapping cameras. An
attempt to hotswap could cause the switch to freeze, in which case it must be restarted.
Camera connectors
Power connector
Two 2-pin terminal blocks for power output (pin 4 is not used).
Function
DC output 24 V DC
0 V DC (-)
N/A
Network connector
Two 2-pin Ethernet terminal blocks.
Wire
2 – blue
7 – yellow
3 – green/white
4 – green
5 – orange/white
6 – orange
8 – black
1, 9 – red
Pin
1, 2
3
4
Connect to
Digital input – I/O terminal connector
Digital output – I/O terminal connector
Ethernet – receiving
Ethernet – receiving
Ethernet – transmitting
Ethernet – transmitting
Power connector
Notes
Power out to camera
N/A
67
Specifications
0 to max 30 V DC
0 to max 30 V DC, open
drain, 100 mA
0 V DC
24 V DC