Advertisement
We offer a technical advisory service on the
telephone to installers and other customers with
problems in the field.
Please call our technical team on:
Tel: +44(0)871 200 3414
Fax: +44(0)871 200 3415
Or alternatively email us on:
info-uk @grohe.com
Remember to quote the exact type of shower,
as written on the front of the shower and on this
leaflet.
The model and serial number are located on the
bottom face of the shower.
Make a note of those numbers here, and be sure
to quote them if you call for advice.
Model Number: 53-56
Serial Number:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
NOTE: You may be charged for a service call
if you do not have the serial number.
It is recommended that the shower unit and
accessories be cleaned using a soft cloth and
that the use of abrasive or solvent based
cleaning fluid be avoided, especially on any
plated finishes.
We recommend that before any cleaning, the
isolating switch be turned off, thus avoiding
accidentally switching on the shower.
All water contains particles of lime-scale, which
build up in the shower handset and unit reducing
the performance.
It is therefore important to clean the shower
handset by simply rubbing the rubber
nozzles, or soaking in a proprietary lime-scale
remover and rinsing thoroughly before use.
. . . . . . . . . . . . . . . . . . . . . . . .
NOTE:
After use it is normal for some water to drip from
the shower handset for a few moments.
This inhibits lime-scale build-up over prolonged
use.
WARNING:
YOU MUST REGULARLY INSPECT
THE SHOWER HOSE FOR WEAR
AND DAMAGE AND REPLACE IF
NECESSARY, OR EVERY 2 YEARS,
WITH OUR APPROVED PART.
WARNING:
IN ORDER TO MAINTAIN THE
PERFORMANCE OF YOUR SHOWER,
YOU MUST CLEAN THE SHOWER
HANDSET REGULARLY.
CLEANING THE FILTER
The filter can be cleaned in order to maintain the
performance of the shower if required.
It is essential that this operation is carried out by
a competent person.
WARNING!
SWITCH OFF THE ELECTRICITY AT
THE ISOLATING SWITCH AND THE
WATER SUPPLY AT THE MAINS
BEFORE REMOVING THE FRONT
COVER.
The inlet filter is situated inside the water inlet
fitting (fig.15).
To gain access to the filter remove the front
cover and backplate lower section.
Unscrew the filter cap on the water inlet fitting
(fig.14).
9
Advertisement
