Advertisement
Ensure temperature Knob is aligned at 6
o'clock, whilst the 'spindle' in the product is
rotated fully clockwise as shown (fig.9).
9
Refit the front cover, and secure by replacing
the top and bottom fastening screws.
Ensure that power select knob has been
correctly aligned by ensuring that all 3 power
settings can be selected.
Ensure that temperature knob has been
correctly aligned by turning from minimum to
maximum flow (approximately 1 full turn) mid
position should be at 12 o'clock.
6. If you have not yet done so, assemble your
Accessories (see separate technical
product information for accessories).
7. Set the power select knob to 'I' (single bar) 9
o'clock position and turn temperature knob
fully anti-clockwise to allow the unit to fill with
water prior to any heat settings being
selected.
8. Place seal washer into the shower hose nut
then tighten to the shower outlet pipe.
Operate the shower first without the handset
to flush out particles.
Fit the seal washer into the other shower
hose nut and then fit the handset.
Operate the shower as in section 4, then
please check:
That the water gets to a satisfactory
temperature and water flow can be
adjusted by the temperature knob.
That the power select knob operates in all
3 positions.
Check again for leaks.
That the holes in the shower handset are
not blocked.
9.
DEMONSTRATE OPERATION TO
USERS, AND LEAVE THIS BOOK WITH
THEM FOR FUTURE REFERENCE
Ensure the electricity and water are turned on to
the unit.
Your shower has 2 control knobs and a
push-button (fig.12).
Knob 'A' controls the power selection.
Knob 'B' controls the temperature of the water.
Button 'C' starts and stops the shower.
TO START THE SHOWER
Press Button 'C' - Water will start to flow.
The 'Power' light will illuminate.
Set your desired power setting - normally 'III'
(fig.10a/10b).
10a
It is recommended that you do not wholly enter
the water spray during this period, especially if
the shower has just been used.
If the water is not at your desired showering
temperature, turn Knob 'B' a small amount until
the desired temperature is achieved.
Turn anti-clockwise for cooler (fig.11a).
Turn clockwise for warmer (fig.11b).
11a
.
7
'III'
-
(3 bars)
'II'
-
(2 bars)
'I'
-
(1 bar)
10b
11b
Advertisement
