Quantum LTO 2U Installation Manual
Quantum lto 2u: install guide
Hide thumbs
Also See for LTO 2U:
- Read this first (1 page) ,
- Quick start manual (42 pages) ,
- Reference (32 pages)
Related Manuals for Quantum LTO 2U
Summary of Contents for Quantum LTO 2U
-
Page 1: Table Of Contents
Step 1: Installing the Chassis Sections onto the 2U Rackmount Chassis Step 2: Installing the Stationary Sections onto the Equipment Rack Step 3: Installing the 2U Rackmount into the Equipment Rack Document 81-81209-06 A01, January 2006 Quantum 2U Rackmount Rail Installation Guide... - Page 2 Made in the USA. Quantum Corporation provides this publication “as is” without warranty of any kind, either express or implied, including but not limited to the implied warranties of merchantability or fitness for a particular purpose. Quantum Corporation may revise this publication from time to time without notice.
-
Page 3: Introduction
Introduction The Quantum Rack Mount Slide Kit is designed to facilitate the mounting of 2U Rackmount systems in standard EIA-310 equipment racks. These telescoping slide rails provide easy access to the 2U Rackmount by allowing you to unlock and slide it forward. -
Page 4: Step 1: Installing The Chassis Sections Onto The 2U Rackmount Chassis
Quantum 2U Rackmount Rail Installation Guide Document 81-81209-06 A01 January 2006 Step 1: Installing the Chassis Sections onto the 2U Rackmount Chassis Figure 1 Removing the Chassis Section Figure 2 Installing the Chassis Sections Onto the Chassis 1 For each set of rails, pull the chassis section forward until it locks into the intermediate section. -
Page 5: Step 2: Installing The Stationary Sections Onto The Equipment Rack
3 Securely tighten the back bracket screws onto the equipment rack’s upright rails. Note: Do not fully tighten the front bracket screws yet – you will do this later. Quantum 2U Rackmount Rail Installation Guide Document 81-81209-06 A01 January 2006 Stationary section... - Page 6 Quantum 2U Rackmount Rail Installation Guide Document 81-81209-06 A01 January 2006 Figure 4 Mounting the Stationary Sections Into the Equipment Rack Upright rails (left side) Upright rails (right side)
-
Page 7: Step 3: Installing The 2U Rackmount Into The Equipment Rack
7 Completely open and close the slides once more to make sure the unit does not bind. 8 Slide the 2U Rackmount all the way into the rack and secure it in place by tightening the thumbscrews on each side. See Quantum 2U Rackmount Rail Installation Guide Document 81-81209-06 A01 January 2006 figure... - Page 8 Quantum 2U Rackmount Rail Installation Guide Document 81-81209-06 A01 January 2006 *81-81209-06 A01* 81-81209-06 A01...