Table of Contents
Advertisement
Notes 1. The minimum operating frequency and minimum operating voltage for rewriting the flash memory are
determined for each device. When using the 78K0/Kx1+, for example, at least a clock of 2 MHz and an
operating voltage of 2.7 V must be supplied.
2. The Port A and Port B pins vary according to the target device. When the target device is the 78K0/KF1+,
these pins are P31 and P32.
Item
On-chip ROM/flash security functions
Event-triggered break functions
Software break functions
Forced break functions
Execution functions
Slow motion
Pseudo real-time RAM monitor
functions
DMM functions
Register manipulation functions
Mask functions
SP setting overlook protection
function
Execution time measurement
Trace functions
10
CHAPTER 1 GENERAL
Table 1-3. List of Debug Functions
10 byte ID code authentication
One break before execution (zero if using a software break)
One access break
2000 points
Included
Continuous execution (free running), execution from cursor position, restart, and step
execution
Included
RAM area: 16 bytes (breaks can be set at up to 8 locations in 1-bit units, enabled by a
temporary break)
Included (implemented as temporary break.)
Included
Reset
Yes
Not included
Not included
User's Manual U17029EJ3V0UM
Specification
Advertisement
Table of Contents
