Digimerge VCE400 Series Quick Reference Manual page 12

Table of Contents

STEP 4

DYNAMIC DNS SETUP FOR REMOTE SECURITY MONITORING

Port forwarding Your Router and the Creation of a DDNS Account with Digimerge is required in order for you to have Remote Internet Access.

Accessing the DVR Locally / Remotely with a PC

Once the DVR and the Local Network have been successfully configured,

a connection can be made with a Local PC (a PC within the same network

as the DVR), or remotely (a PC from outside the network via the Internet).

NOTE: YOUR COMPUTER AND YOUR DVR MUST BE

CONNECTED TO THE SAME ROUTER

Logging Into Live Monitoring

Once the DigiClient has been installed and has been launched on the computer,

a pop-up window will appear. It should ask you to Register an Admin Password

(this password is separate from the numeric DVR password, this password will

only be used to login to the DigiClient Software).

The DigiClient software interface will load once you have successfully logged in.

Click on the "DVR List" button located in the top left of the DigiClient 4.0 Screen.

Information in this document is subject to change without notice. As our products are subject to continuous improvement, Digimerge Technologies Inc. reserves the right to modify product design, specifications and prices, without notice and without incurring any obligation. E&OE © 2007 Digimerge. All rights reserved.

VCE400 Series QSG_EN_R1 Page 12

(continued)

The DVR List should appear, fill in the appropriate network and

password information and click the "Add" Button.

The DVR information should be populated in the above list,

Select the DVR by clicking on it, and then click on the Connect

Button. A login window should appear, Enter in the DVR's 8

digit password, and press "Ok".

If the DVR and the software are correctly configured, the

cameras should display in the DigiClient Screen.

It's all on the web

