Electronic Crossover Ignition System Operations; Side Burner Maintenance - Weber SPIRIT 89963 Owner's Manual

eleCtroNiC CrossoVer
If the Electronic Crossover ® Ignition System fails to ignite the BURNER 1, light BURNER
1 with a match . If BURNER 1 lights with a match, then check the Electronic Ignition .
• Check that both of the ignition wires are attached at the igniter module properly.
• Check that the Electronic Ignition button is working by listening and looking for sparks
at BURNER 1 .
replace Battery if Necessary
AAA alkaline battery only.
if the electronic Crossover ignition system still fails to light, contact the
®
Customer service representative in your area using the contact information on
our web site. log onto www.weber.com

side BurNer MaiNteNaNCe

m warNiNG: all gas controls and supply valves should be in
the off position.
Make sure black wire is connected between the igniter and electrode .
Make sure white wire is connected between the igniter and grounding clip .
Spark should be a white/blue color, not yellow .
A) Igniter Wire (1)
B) Ground wire (2)
C) Burner (3)
side Burner Grate
head retention Clip
side Burner ring & head
igniter electrode
m warNiNG: the side burner orifice (4) must be parallel to the
side burner tube opening (5).
20
iGNitioN sYsteM oPeratioNs
®
.
®
◆
Control Knob
igniter Button
◆
5
maINTENaNcE
4
3
3
1 1
2 2
1 1