Pride Mobility Jazzy EVO Series Owner's Manual page 31

Table of Contents

Advertisement

V I I . C A R E A N D M A I N T E N A N C E
Wheel Replacement
If you have pneumatic tires and you have a flat tire, replace the tube. If your chair is equipped with a solid tire
insert, then you must replace the whole wheel assembly. Replacement tires, tubes, and wheel assemblies are
readily available through your authorized Pride Provider.
WARNING! The wheels on your power chair should only be serviced or replaced by an authorized
Pride Provider or a qualified technician.
WARNING! Be sure that the power to the controller is turned off and the power chair is not in
freewheel mode before performing this procedure.
WARNING! When changing a tire, remove only the center lug nut and washer, then remove the
wheel. If any further disassembly is required, deflate the tire completely or it may explode.
Follow these easy steps for a quick and safe repair
for both pneumatic and solid tires:
1. Turn off the power to the controller.
2. Make sure that the power chair is in drive mode.
See figure 5.
3. Raise and support the power base so that the
wheel is at least 1 in. (2.5 cm) off of the ground.
4. If you are changing a pneumatic tire, completely
deflate it before removing the wheel.
5. Remove the cap cover, if equipped.
6. Remove the drive wheel nut and washer from the
axle. See figure 18.
7. Remove the drive wheel from the axle. Make sure
that you keep the key.
8. Slide the wheel back onto the axle. Make sure that
the key is in the axle slot.
WARNING! Ensure that the axle key
is properly installed into the axle
slot when mounting the wheel. If not
installed securely, the braking and
drive systems are disengaged which
may cause personal injury or product
damage.
9. Reinstall the drive wheel nut and washer onto the axle and tighten. See figure 16.
WARNING! Make sure both the nut and washer are reinstalled and tightened properly.
10. Reinstall the cap cover, if equipped.
11. Inflate the pneumatic tire to the psi/bar/kPa air pressure rating indicated on each tire.
12. Remove the power chair from the base support.
Jazzy EVO Series
1. Motor
2. Key
3. Axle
4. Drive Wheel
1
Figure 18. Drive Wheel Removal
www.pridemobility.com
Identification Key
5. Drive Wheel Nut
6. Drive Wheel Washer
7. Cap Cover
2
4
3
5
7
6
31

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jazzy evo 613Jazzy evo 613 li

Table of Contents