Pride Mobility Jazzy EVO Series Owner's Manual page 14

V. C O M F O R T A D J U S T M E N T S
NOTE: The most common configuration of the
seat adjustment hardware is shown in figure 9.
Your product may be equipped with a different
configuration. All configurations operate in a
similar manner.
Manual Recline Seatback Adjustment
If your power chair is equipped with a manual recline
seatback, you can adjust the seatback angle with the
seatback release lever. The lever is located on the
right side of the seat base. See figure 1.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with a limited-recline
seatback, you can adjust the seatback up to a 115°
angle.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat
hinge. See figure 9.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge
and tighten.
Armrest Width Adjustment
You can change each armrest's width independently of the other.
NOTE: Changing the armrest width may increase the overall width of your power chair.
To change the armrest width:
1. Locate the adjustment hardware on each side of the armrest receiver bracket. See figure 9.
2. Loosen the adjustment hardware.
3. Slide the armrests in or out to the desired width.
4. Tighten the adjustment hardware.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Loosen the jam nut. See figure 9.
3. Turn the adjusting screw to raise or lower the front of the armrest.
4. Tighten the jam nut to lock the adjusting screw into place.
14
1. Jam Nut
2. Armrest Angle Adjusting Screw
3. Armrest Height Adjusting Setscrews
4. Seatback Angle Adjusting Screw
5. Armrest Knob
6. Setscrew
7. Controller Bracket Receiver
1
2
3
4
5
Figure 9. Armrest and Seatback Adjustments
www.pridemobility.com
Identification Key
Jazzy EVO Series
7
6