Adding Gear Oil - KTM 50 SX 2019 Owner's Manual

16.5

Adding gear oil

Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
(50 SX Mini)
–
Place an appropriate container under the engine.
–
Remove oil drain plug
–
Let the gear oil drain fully.
–
Thoroughly clean the oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount and tighten the oil drain plug with the magnet and
new seal ring.
S00883-10
Guideline
Oil drain plug with
magnet
–
Remove filler plug
Gear oil
Info
Too little gear oil or poor-quality gear oil results in pre-
mature wear to the transmission.
H01460-10
–
Mount and tighten filler plug
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
SERVICE WORK ON THE ENGINE 16
1
with the magnet.
M12x1.5 20 Nm
(14.8 lbf ft)
2
with the O-ring, and fill up with gear oil.
0.20 l Gear oil
(0.21 qt.) (ATF Dexron 3)
(
2
with the O-ring.
p. 101)
p. 126)
103