Hamilton Beach Clean Cut 76375, 76380, 76386, 76388R - Can Opener Manual

Also See for Clean Cut 76375:

Table of Contents

Parts and features

Parts and features - Part 1
Parts and features - Part 2

Place can opener on level surface.
Plug cord into electrical outlet.
Raise piercing lever up.
Place rim of can firmly under can guide pin and against the geared wheel.
Press piercing lever all the way down.
The motor will begin turning can and cutting lid. (It is not necessary to hold the piercing lever down or to hold the can during the cutting action.)
The motor will automatically stop when the can is open.
Remove can from can opener and check can contents to remove any pieces of label or metal shavings.

Place cutting edge of knife in the knife slot located on the back of the can opener.
Draw the knife blade through the slot several times.
Clean knife after sharpening.
NOTICE: Serrated blades should never be inserted into this unit.

Electric Shock Hazard. Do not immerse the can opener in water or any other liquid.

Unplug cord from electrical outlet.
To remove the cutting unit: Press release button.
Wash cutting unit in hot soapy water. Rinse and dry thoroughly. Can also be placed in top rack of dishwasher.
Wipe the can opener body and the area behind the cutting unit with a damp cloth. Never immerse the can opener in water.
To re-assemble: Raise lever slightly then slide the cutting unit onto the body until the release button clicks into place.

The can opener will easily open all standard size cans.
If there is a bump, dent, or heavy seam in rim of can, openother end of the can or position the cutting unit to start opening just beyond the problem.
The motor of your can opener is permanently lubricated and will require no oiling.
To use cord storage on back of opener, push in or pull out cordas needed.
To lock the cord, turn cord sideways and slide up into cord lockslot.
If piercing lever does not move freely, remove and clean the cutting unit.