Kärcher NT 22/1 Ap Manual page 10

Working with power tools
Only for devices with a built-in sock-
et:
DANGER
Danger of electric shock
Risk of injury and damage.
The socket is only intended for direct
connection of power tools to the vacu-
um cleaner. Any other use of the sock-
et is prohibited.
1. Plug the mains plug of the power
tool into the power socket on the
vacuum cleaner. The vacuum clean-
er is in Standby mode.
2. Set the main switch to program "2".
Note
The vacuum cleaner is automatically
switched on and off with the power tool.
Note
The vacuum cleaner has a startup de-
lay of up to 0.5 seconds and an after-
running time of up to 5 seconds.
Note
See the Technical data for the permis-
sible power rating of the power tool.
3. Remove the angle piece from the
suction hose.
Illustration G
4. Install the tool adapter on the suc-
tion hose.
5. Connect the tool adapter to the pow-
er tool.
Illustration H
6. Regulate suction power on the suc-
tion control of the tool adapter (vari-
able).
Semi-automatic filter dedusting
Note
Actuating the filter dedusting every 5-
10 minutes extends the working time of
the cartridge filter.
10
Note
The semi-automatic filter dedusting
can only be switched on when the de-
vice is switched on.
1. Press the semi-automatic filter de-
dusting button 5x. The cartridge filter
is then cleaned by a blast of air
(pulsing noise).
2. Power dedusting (for particularly se-
vere contamination of the cartridge
filter): Close off the suction pipe or
angle piece with your hand and
press the semi-automatic filter de-
dusting button 5x at the same time.
Draining the dirt receptacle
WARNING
Waste water hazard
Environmental pollution
Observe local waste water treatment
regulations.
● The suction duct is equipped with a
float.
● When the maximum permissible
waste water level in the container is
reached, the suction volume is inter-
rupted.
1. Switch off the device at the main
switch.
2. Empty the container.
Switching off the device
1. Press the semi-automatic filter de-
dusting button 5x.
2. Switch off the device at the main
switch.
3. Pull out the mains plug.
Each time after use
1. Empty the container.
2. Vacuum off the inside and outside of
the device and clean with a moist
cloth.
English