Toyota RAV4 HYBRID 2017 Manual page 593

3
Connect the jumper cables according to the following procedure:
1
Connect a positive jumper cable clamp to the exclusive jump
starting terminal on your vehicle.
2
Connect the clamp on the other end of the positive cable to the
positive (+) battery terminal on the second vehicle.
3
Connect a negative cable clamp to the negative (-) battery termi-
nal on the second vehicle.
4
Connect the clamp at the other end of the negative cable to a
solid, stationary, unpainted metallic point away from the exclusive
jump starting terminal and any moving parts, as shown in the
illustration.
4
Start the engine of the second vehicle. Increase the engine speed
slightly and maintain at that level for approximately 5 minutes to
recharge the 12-volt battery of your vehicle.
5
Open and close any of the doors of your vehicle with the power switch
off.
6
Maintain the engine speed of the second vehicle and start the
hybrid system of your vehicle by turning the power switch to ON
mode.
RAV4-HV_OM_OM42B03U_(U)
8-2. Steps to take in an emergency
1
4
593
2
3
8