Table of Contents
Advertisement
Partially install two light kit
screws, found in the
hardware bag, through the gasket
halfway into the motor housing as
shown. It does not matter which
two screw holes you choose.
bag
Partially install two of the light kit screws
found in the
bag. It does not matter
which two screw holes you choose. Connect
the single-pin connectors from the LED
assembly to the connectors from the fan.
Connect the white wires together. Connect
the blue and black wires together.
Tab
Notch
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Ceiling Bracket
Downrod
Assembling the LIght Kit
2 of 6
Light Kit Screw
bag
2 of 6
Light Kit Screw
Align the keyhole slots in the light kit
housing with the two screws. Make
sure all the wires from the fan and the
light kit are snug inside the center of
the light kit, not pinched in between
the upper switch housing and the light
kit or hanging out of the sides.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Installing the Glass
Hanging Fan
Wiring
Feed the wire plug through the
center hole of the upper switch
housing and gasket, then wrap
keyhole slots around the screws
and twist counterclockwise.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
Canopy
Blades
bag
Insert the third screw, found
in the
hardware bag, into
place and then tighten all three
screws.
bag
Turn the light kit counterclockwise until the
light kit screws are firmly situated in the
narrow end of the keyhole slots. Install the third
screw and tighten all three screws securely.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light
Remote
Troubleshooting
1886
1 of 6
Light Kit Screw
1 of 6
Light Kit Screw
8
Advertisement
Table of Contents
