Assembling The Light Kit - Hunter 52594 Installation Manual

Remove a pre-installed assembly
screw. It does not matter which
screw you choose.
Insert the saved assembly screw. Firmly tighten all
the three screws.
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Ceiling Bracket Downrod

Assembling the Light Kit

1 of 1
Assembly Screw
Feed the 9-pin plug connector coming
from the bottom of the motor housing
through the center hole in the light kit
assembly. Connect it to the plug connector
found in the switch housing area of the
light kit assembly. Make sure to line up
the colored markings on the connectors.
1 of 1
Assembly Screw
Carefully push all switch housing components into the
switch housing, then install the switch housing plate
using the two pre-installed light kit screws.
Installing the Bulbs and Glass
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
Hanging Fan Wiring
Tab
Notch
Canopy Blades
Align the keyhole slots in the top of the light kit
assembly with the partially installed screws.
Wrap the keyhole slots around the screws and
twist counterclockwise.
2 of 2
Light Kit Screw
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Light Bulbs/Glass
1886
8
Remote