Weslo pursuit R 1.2 User Manual page 7

5. Attach the Seat (11) to the Seat Post (10)
with four M8 Locknuts (9) and four M8 Spring
Washers (8). Note: The Locknuts and Spring
Washers may be preattached to the Seat.
Press the Frame Bushing (4) into the Frame
(1). (Note: The Frame Bushing may be preas-
sembled.) Next, insert the Seat Post (10) into the
Frame.
Align one of the holes in the Seat Post (10) with
the hole in the Frame (1). Insert the Seat Knob
(31) into the Frame and the Seat Post. Make
sure that the Seat Knob is inserted into one
of the holes in the Seat Post; do not insert the
Seat Knob under the Seat Post. Then, tighten
the Seat Knob into the Frame.
6. Identify the Right Pedal (22). Remove only the
Right Pedal Nut (47) and the Pedal Bushing (46)
from the Right Pedal.
Next, slide a 1/2" Flat Washer (44) onto the shaft
of the Right Pedal (22), and insert the shaft into
the right Pedal Arm (49). Then, orient the Pedal
Bushing (46) as shown, slide it onto the shaft of
the Right Pedal, and insert it into the Pedal Arm.
Tighten the shaft of the Right Pedal (22) clock-
wise into the right arm of the Crank (20) as
firmly as possible. Then, tighten the Right Pedal
Nut (47) clockwise onto the shaft. Tighten the
Right Pedal and the Right Pedal Nut as firmly
as possible.
Repeat this step to attach the Left Pedal (not
shown), turning the Left Pedal and the Left
Pedal Nut (not shown) counterclockwise.
7. Make sure that all parts are properly tightened before you use the exercise bike. After the exercise
bike is assembled, inspect it to make sure that it is assembled correctly and that it functions properly.
Note: Extra parts may be included. Place a mat under the exercise bike to protect the floor or carpet from
damage.
5
8
9
31
6
46
44
22
49
7
11
8
9
10
Hole
4
1
47
20