Electrical Connection; Prior To Inital Start-Up; Control Panel - AEG SANTO 60270-18 KG Operating Instructions Manual

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if sup-
ply voltage and current values correspond with those of the mains at the
installation location.
e.g.:
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
A correctly installed, earthed socket is required for the electrical supply. The
supply must have a fuse rating of at least 10 Amps.
If the socket is not accessible once the appliance is built in, the electrical
installation must include suitable means of isolating the appliance from the
mains (e.g. fuse, cut-out, current trip or similar with a minimum contact
separation of 3 mm).
Attention: The mains connection cable may only be replaced by a skilled
electrician. Please contact your dealer or our customer service department
for repairs.
Prior to Initial Start–Up
• Please clean the appliance interior and all accessories prior to initial start-
up (see section: "Cleaning and Care").

Control panel

The green pilot lamp (C), which comes on when the panel is switched on and
the mains voltage is available. In this switch position, the refrigerating unit
automatically operates by system control.
30
AC 220 ... 240 V
220 ... 240 V~
A B C
50 Hz
D
50 Hz or