SANTO N 9 18 41-4 i Integrating Fridge-Freezer Operating and Installation instruction...
Dear customer, Before placing your new refrigerator/freezer into operation please read the- se operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance.
• Alterations or changes to the freezer are not permitted for reasons of safety. • If you use the refrigerator in a commercial application or for purposes other than the cooling, freezing or frozen storage of foods, please obser- ve all valid legal regulations for your application.
• Bottles and cans must not be placed in the freezer compartment. They can burst when the contents freeze, high carbonate content drinks can even explode! Never store lemonade, juices, beer, wine, sparkling wine etc.
Disposal Appliance Packaging Information All materials are environmentally sound! They can be dumped or burned at an incinerating plant without danger! About the materials: The plastics can be recycled and are identified as fol- lows: >PE< for polyethylene, e.g. the outer covering and the bags in the interior. >PS<...
Shelf holders Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transporta- tion. To remove them proceed as follows: Raise the shelf from the back, push it in the direction of the arrow until it is free and remove the retainers.
Operating and indicator panel Fridge °C Mains pilot indicator (green) Fridge button ON/OFF Temperature setting button (for warmer temperatures) Temperature display Temperature setting button (for colder temperatures) COOLMATIC function "on" indicator (yellow) COOLTMATIC button Temperature setting buttons The temperature is adjusted using the “C“ (+) and “E“ (-) buttons. These but- tons are connected to the temperature display.
Important: If the fridge compartment is off, the door must be closed in order that the freezer is working properly. In this condition, the electronic control of the appliance functions auto- matically and periodically circulating the air to prevent unpleasant smel- ls and humidity.
Interior Accessories Storage Shelves The glass shelf above the fruit and vegetable compartment always remain in position, to ensure fruit and vegetables stay fresh longer. The remaining storage shelves can be adjusted to various heights: Pull the storage shelf forward until it can be tipped up or down and remo- ved.
Left slider: Ventilation slots closed. When the ventilation slots are closed, the natural moisture content of the food in the fruit and vegetable com- partments is preserved for longer. Variable Storage Box Some models are equipped with a variable storage box which is fitted under a door shelf compartment and can be slid sideways.
Milk bootles: these should have a cap and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. Operating and indicator panel appliance °C Mains pilot indicator (green) Button ON/OFF for the appliance Temperature setting button (for warmer temperatures) Temperature display...
DESIRED temperature means: The temperature that has been selected for inside the freezer. The DESIRED temperature is indicated by flashing numbers. ACTUAL temperature means: The temperature display indicates the current temperature inside the freezer. The ACTUAL temperature is indicated with illuminated numbers.
FROSTMATIC button again. The yellow light goes out. Alarm reset button In the event of an abnormal temperature rise inside the freezer (e.g. power cut) warning light (O) will start to flash and a buzzer will sound. After the temperature has returned to normal, the warning light (O) will continue to flash, although the buzzer has stopped.
• Bottles and cans must not be placed in the freezer. They can burst when the contents freeze, high carbonate content drinks can even explode! Never store lemonade, juices, beer, wine, sparkling wine etc.
Preparation of Ice Cubes Fill the ice cube tray 3/4 full with cold water, place it in the freezer com- partment and leave to freeze. To loosen the frozen cubes, either bend the ice cube tray or hold it under running water for a few seconds.
Cleaning and Care For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly. Warning! • The appliance may not be connected to the mains during cleaning. Dan- ger of electrical shock! Before cleaning switch the appliance off and rem ve the plug from the mains, or switch off or turn out the circuit breaker or fuse.
Energy Saving Tips • Do not install the appliance near radiators or other sources of warmth. High ambient temperatures cause longer, more frequent operation of the compressor. • Ensure sufficient air circulation and exhaust at the appliance base and at the back wall of the appliance.
What to do if ... Correcting Malfunctions A malfunction may be caused by only a minor fault that you can rectify yourself using the following instructions. Do not perform any other work on the appliance if the following information does not provide assistance in your specific case.
Malfunction The freezer temperature is not sufficient, red light lights up, temperature signal sounds Heavy build up of frost, possi- bly also on the door seal. Unusual noises. The compressor does not start immediately after changing the temperature setting. If the door remains open for more than 7 min., the light...
Changing the light bulb Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the circuit breaker. Light bulb data: Replace the lamp with one of the same power (the maximum power is shown on the light diffuser).
GUARANTEE CONDITIONS Standard guarantee conditions We, AEG, undertake that if within 12 months of the date of the purchase this AEG applian- ce or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our discretion repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: ·...
Installation Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING – THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.
Positioning This appliance should only be installed at a location where the ambient tem- perature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification: SN +10°C to + 32°C +16°C to + 32°C...
To buy accessories, consumables and spare parts at our online shop please visit: http://www.aeg-electrolux.co.uk...