Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Vertiv PSA4-1000MT120
Summary of Contents for Vertiv PSA4-1000MT120
- Page 1 Liebert® PSA4™ 1000 – 1500 VA Installer/User Guide...
- Page 2 Technical Support Site If you encounter any installation or operational issues with your product, check the pertinent section of this manual to see if the issue can be resolved by following outlined procedures. For additional assistance, visit https://www.VertivCo.com/en-us/support/...
-
Page 3: Table Of Contents
1.7 Maintenance and Battery Replacement 1.7.1 Battery Charging 1.7.2 Precautions 1.7.3 Battery Replacement Precaution 1.7.4 Information for the Protection of the Environment 1.7.5 Battery Replacement Procedure 1.7.6 Specifications Appendices Appendix 1: Technical Support Vertiv | Liebert® PSA4™ Installer/User Guide |... - Page 4 Vertiv | Liebert® PSA4™ Installer/User Guide |...
-
Page 5: Liebert Psa4 Overview
Shielded communication-interface cables must be used with this product. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Vertiv | Liebert® PSA4™ Installer/User Guide |... -
Page 6: Controls And Indicators
Type B USB port for USB communication, monitoring and control. RJ11/45 connectors for phone/fax/modem or network surge protection. Battery-backed and surge-protected output power receptacles. Coax Cable Line In for cable modem, DSS receiver, or cable-TV converter surge protection. Vertiv | Liebert® PSA4™ Installer/User Guide |... -
Page 7: Installation
NOTE: While every precaution has been taken to ensure that the battery is in good condition, we recommend allowing the UPS to charge the battery for at least 4 hours prior to providing full back-up time protection for any utility-power abnormality. Vertiv | Liebert® PSA4™ Installer/User Guide |... -
Page 8: Ups Operation
“full,” the Fault LED flashes on/off, and the UPS sounds 1 beep every half second (AC and Battery modes). The alarm remains on until the excess load is removed or the UPS's self-protection circuit shuts down the UPS. Vertiv | Liebert® PSA4™ Installer/User Guide |... -
Page 9: Ups Fault
Clean the UPS with a dry cloth. Do not use liquid or aerosol cleaners. • Never block or insert any objects into the ventilation holes or other openings of the UPS. • Do not place the UPS power cord where it might be damaged. Vertiv | Liebert® PSA4™ Installer/User Guide |... -
Page 10: Battery Replacement Precaution
4. Grasp the battery and gently pull it out far enough to disconnect the battery wires. 5. Disconnect the battery positive (Red) wire and the battery negative (Black) wire. (item 3). 6. Remove the battery and set aside. Vertiv | Liebert® PSA4™ Installer/User Guide |... - Page 11 11. Re-install the battery compartment retaining screw (item 5). 12. Properly dispose of the old batteries at an appropriate recycling facility or return them to Vertiv™ in the packing material for the new batteries. 13. The UPS is now ready for normal operation.
-
Page 12: Specifications
Leoch / DJW12-9.0 Battery Quantity x VDC x Ah 2 x 12V x 7.0 / 7.2Ah 2 x 12V x 9.0Ah Battery Backed Outlets (4) NEMA 5-15R Surge Only Outlets (4) NEMA 5-15R Vertiv | Liebert® PSA4™ Installer/User Guide |... - Page 13 Audible Noise <40 dBA @ 3 ft (1 m) from all sides Agency Safety RFI / EMI FCC Subpart J, Class B Surge Immunity ANSI 62.41 (IEC 62040-2 2nd Edition) Transportation ISTA Procedure 1A Vertiv | Liebert® PSA4™ Installer/User Guide |...
- Page 14 This page intentionally left blank. Vertiv | Liebert® PSA4™ Installer/User Guide |...
-
Page 15: Appendices
Liebert product. Please call or e-mail us: Technical support: e: liebert.upstech@vertivco.com p: 1-800-222-5877 menu option 1 Monitoring support: e: liebert.monitoring@vertivco.com p: 1-800-222-5877 menu option 2 Warranty support: e: microups.warranty@vertivco.com p: 1-800-222-5877 menu option 3 Vertiv | Liebert® PSA4™ Installer/User Guide |... - Page 16 This page intentionally left blank. Vertiv | Liebert® PSA4™ Installer/User Guide |...
- Page 18 VertivCo.com | Vertiv Headquarters, 1050 Dearborn Drive, Columbus, OH, 43085, USA © 2017 Vertiv Co. All rights reserved. Vertiv and the Vertiv logo are trademarks or registered trademarks of Vertiv Co. All other names and logos referred to are trade names, trademarks or registered trademarks of their respective owners. While every precaution has been taken to ensure accuracy and completeness herein, Vertiv Co.
Need help?
Do you have a question about the PSA4-1000MT120 and is the answer not in the manual?
Questions and answers