Vertiv Liebert PSA4 Installer/User Manual
Hide thumbs
Also See for Liebert PSA4:
- Quick installation manual (2 pages) ,
- Installer/user manual (18 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Vertiv Liebert PSA4
Summary of Contents for Vertiv Liebert PSA4
- Page 1 Liebert® PSA4™ 500 – 700 VA Installer/User Guide...
- Page 2 Technical Support Site If you encounter any installation or operational issues with your product, check the pertinent section of this manual to see if the issue can be resolved by following outlined procedures. For additional assistance, visit https://www.VertivCo.com/en-us/support/...
-
Page 3: Table Of Contents
1.7 Maintenance and Battery Replacement 1.7.1 Battery Charging 1.7.2 Precautions 1.7.3 Battery Replacement Precaution 1.7.4 Information for the Protection of the Environment 1.7.5 Battery Replacement Procedure 1.7.6 Specifications Appendices Appendix 1: Technical Support Vertiv | Liebert® PSA4™ Installer/User Guide |... - Page 4 Vertiv | Liebert® PSA4™ Installer/User Guide |...
-
Page 5: Liebert Psa4 Overview
The Liebert PSA4 should be located near the wall outlet. Do not use extension cords between the wall outlet and the UPS. The Liebert PSA4 is designed for small office and home use only. It is not recommended to be used with life-support equipment or applications. -
Page 6: Controls And Indicators
The Liebert PSA4 is shipped with the following items: • CD with Liebert MultiLink® Shutdown Software and User manual (electronic version) • USB cable; one 1.8 m (6 ft.) long • Coax cable; one 1 m (3 ft.) long • User Manual with warnings safety instructions and WEEE recycling sheet (ISO 14001 compliance) -
Page 7: Installation
Surge-protected-only output-power receptacles. 1.2 Installation Install the Liebert PSA4 in a temperature-controlled environment that is free of corrosive and conductive contaminants. Avoid locations near heat or water sources and exposed to direct sunlight. For proper ventilation, leave approximately 2 to 4 inches clearance on all sides of the UPS. -
Page 8: Ups Operation
“full,” the Fault LED flashes on/off, and the UPS sounds 1 beep every half second (AC and Battery modes). The alarm remains on until the excess load is removed or the UPS's self-protection circuit shuts down the UPS. Vertiv | Liebert® PSA4™ Installer/User Guide |... -
Page 9: Ups Fault
The Liebert PSA4 charges the batteries continuously when it is connected to the utility input power. If the Liebert PSA4 will be stored for a long time, we recommend connecting the UPS to input power for at least 24 hours every 4 to 6 months to ensure full recharge of the batteries. -
Page 10: Battery Replacement Precaution
4. Grasp the battery and gently pull it out far enough to disconnect the battery wires. 5. Disconnect the battery positive (Red) wire and the battery negative (Black) wire. (item 3). 6. Remove the battery and set aside. Vertiv | Liebert® PSA4™ Installer/User Guide |... - Page 11 11. Re-install the battery compartment retaining screw (item 5). 12. Properly dispose of the old batteries at an appropriate recycling facility or return them to Vertiv™ in the packing material for the new batteries. 13. The UPS is now ready for normal operation.
-
Page 12: Specifications
Leoch / DJW12-5.0 Leoch / DJW12-7.0 Battery Quantity x VDC x Ah 1 x 12V x 5.0Ah 1 x 12V x 7.0Ah Battery Backed Outlets (4) NEMA 5-15R Surge Only Outlets (4) NEMA 5-15R Vertiv | Liebert® PSA4™ Installer/User Guide |... - Page 13 Audible Noise <40 dBA @ 3 ft (1 m) from all sides Agency Safety RFI / EMI FCC Subpart J, Class B Surge Immunity ANSI 62.41 (IEC 62040-2 2nd Edition) Transportation ISTA Procedure 1A Vertiv | Liebert® PSA4™ Installer/User Guide |...
- Page 14 This page intentionally left blank. Vertiv | Liebert® PSA4™ Installer/User Guide |...
-
Page 15: Appendices
Liebert product. Please call or e-mail us: Technical support: e: liebert.upstech@vertivco.com p: 1-800-222-5877 menu option 1 Monitoring support: e: liebert.monitoring@vertivco.com p: 1-800-222-5877 menu option 2 Warranty support: e: microups.warranty@vertivco.com p: 1-800-222-5877 menu option 3 Vertiv | Liebert® PSA4™ Installer/User Guide |... - Page 16 This page intentionally left blank. Vertiv | Liebert® PSA4™ Installer/User Guide |...
- Page 18 VertivCo.com | Vertiv Headquarters, 1050 Dearborn Drive, Columbus, OH, 43085, USA © 2017 Vertiv Co. All rights reserved. Vertiv and the Vertiv logo are trademarks or registered trademarks of Vertiv Co. All other names and logos referred to are trade names, trademarks or registered trademarks of their respective owners. While every precaution has been taken to ensure accuracy and completeness herein, Vertiv Co.