Advertisement
Troubleshooting
problem
Tool will not start.
1. Cord not connected.
2. No power at outlet.
3. Tool's thermal reset breaker
tripped (if equipped).
4. Internal damage or wear.
(Carbon brushes or
switch, for example.)
Tool operates slowly. Extension cord too long or
cord diameter too small.
Performance
1. Accessory dull or damaged.
decreases over time.
2. Carbon brushes worn
or damaged.
Excessive noise
Internal damage or wear. (Carbon
or rattling.
brushes or bearings, for example.)
Overheating.
1. Forcing tool to work too fast.
2. Accessory misaligned.
3. Accessory dull or damaged.
4. Blocked motor housing vents.
5. Motor being strained by long or
small diameter extension cord.
Laser Guide will
1. Laser is off.
not illuminate.
2. Laser opening is dirty or blocked.
3. Laser damaged.
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power
supply before service.
Item 69077
possible Causes
For technical questions, please call 1-800-444-3353.
Likely Solutions
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker. If breaker
is tripped, make sure circuit is right capacity
for tool and circuit has no other loads.
3. Turn off tool and allow to cool.
Press reset button on tool.
4. Have technician service tool.
Eliminate use of extension cord. If an extension
cord is needed, use one with the proper diameter
for its length and load. See Extension Cords
in Grounding section on page 6.
1. Keep cutting accessories sharp. Replace as needed.
2. Have qualified technician replace brushes.
Have technician service tool.
1. Allow tool to work at its own rate.
2. Check and correct accessory to
fence and/or table alignment.
3. Keep cutting accessories sharp. Replace as needed.
4. Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator while
blowing dust out of motor using compressed air.
5. Eliminate use of extension cord. If an extension
cord is needed, use one with the proper diameter
for its length and load. See Extension Cords
in Grounding section on page 6.
1. Press Laser Button to turn Laser on.
2. Turn the Laser "OFF". Then, clean the laser opening.
3. Have a qualified service technician
check the tool for internal damage.
Page 13
Advertisement
