STEP 4a: Take 2 board to timber connectors and fasten them on either side of
the bottom animal barrier gate pole with the screws provided and a power drill.
This will allow the animal barrier gate and board gate to swing as a complete
door. If you are installing this connector onto one-inch profile boards, insert the
spacer block in between the gate to board connector and board before drilling
in your screws.
STEP 4b: For a 3-level design, take your metal gate brace and fasten it over 2 of the
left gate boards with the screws provided and a power drill. Install the gate braces
on the inside portion of the garden and make sure that the screw holes are not over
the edge where the 2 boards meet (see picture).
Repeat this step for the right gate.
For a 4-level design, install an additional gate brace on each door.
Repeat Steps 2, 3, & 4 for the second gate entrance.
Need help?
Do you have a question about the Colosseum 800002109 and is the answer not in the manual?