FRAME IT ALL Colosseum 800002109 Installation Instructions page 2

ASSEMBLY INSTRUCTIONS – Level 1 Continued
Step 2: Layout the Boards for the first level according to the number of the
board in Step 1.
Note: It is especially important to layout Boards 2 & 3 in the exact orientation
shown in the diagram below.
2
5
1
1
2
The gate Board (Board 1) on level 1 is kept uncut for 2" profile boards to act as a
level surface for the gate to swing on. You can choose to cut this Board if you want
it to be apart of the swinging gate.
IMPORTANT: If you connect any brackets incorrectly, they can be removed by
inserting a flathead screwdriver into the opening of the snap-lock plugs, pushing into
the nub and twisting upwards.
1 2
5
3
3
1
1
5
3 3
1 2
Step 3: When connecting the boards for the first level, insert the stacking
stakes upside down so the stake is pointing to the sky. This will allow you to
adjust the shape of your frame before driving the stakes into the ground.
Install anchor stakes on the joints indicated by a circle on the diagram to the
left. All other joints on the ground level will use stacking stakes.
Step 4: Once you finish with the adjustments of your base level frame, flip
over the stakes and hammer them into the ground.
STEP 5:
Connect the boards for your second level in the quantity and orientation as shown below.
4
1. Connect x 4ft Boards with Stacking Brackets on
both ends in alternating orientation.
2. Connect a 2ft and 4ft board using the
L-Brackets to create a 90° board
Segment. Then, connect stacking
brackets on both open ends of each
board in the orientation shown on the right.
2
Repeat this step to create sets
of 2a and 2b board segments.
10
3. Connect x Curved boards with stacking brackets
on both ends in alternating orientation .
(Bracket all curved boards exactly as shown to the right)
4
4. Connect x 2ft boards with stacking brackets
0n both ends in alternating orientation.
4
5. Connect x Cut gate Boards with a stacking bracket
on the board end with pre-drilled holes.
1
2a
2b
3
4
5