FRAME IT ALL Colosseum 800002109 Installation Instructions page 3

Step 6: Before stacking your boards, lay them out around your 1
NOTE: Stacking stakes will be used for all additional levels and can insert into
the top of existing stakes.
5
2b
4
2b
1
1
2a
2a
5
Step 7. Start your 2
joints. Have the bracket for the gate board (5) on the bottom
of the joint as shown in the picture to the left. Then connect
the 90 ° board segments (2) and continue from this point
stacking the remaining 2
Skip to step 1 of the Animal Barrier assembly if you are
assembling a 2-level bed design.
Step 8: Repeat steps 5, 6, & 7 for each additional level of your design.
st
level frame.
5
2a
4
2a
1
1
4
2b
2b
5
nd
level by connecting the front gate
nd
level boards.
ASSEMBLY INSTRUCTIONS – Animal Barrier Gate
Step 1: Install an adapter cap (Part 21) on top of each of the 10 joints on your final level.
Quantities doubled for 2 level Barrier
NOTE: Part 12
will not be used
if installing the
gate to Board
connector