Table of Contents
Advertisement
ORIGINAL INSTRUCTIONS
READ MANUAL BEFORE USE
Precautions when working with batteries
1.
Always wear protective clothing e.g. face visor, gloves and overalls when working with batteries.
2.
Whenever possible always use a properly designated and well-ventilated area for charging.
Do not smoke or bring naked flames into the charging area.
3.
Remove any metallic items from hands, wrists and neck i.e. rings, chains etc. before working on a battery.
4.
Never rest tools or metallic objects on top of the battery.
5.
When charging is complete disconnect from the mains supply.
6.
The batteries must be removed from the machine before it is scrapped.
7.
The machine must be disconnected from the supply when removing the battery.
8.
To remove the batteries:- Disconnect machine from the mains supply (if charging) and ensure batteries are switched
off with circuit disconnect switch (see page 19). Disconnect hoses from separator and tanks.
Remove separator and tanks. Unscrew battery strap fixings and remove.
Undo battery terminals and remove. Remove batteries.
9.
The batteries are to be disposed of safely and in accordance with the battery directive.
10. Only use genuine Numatic replacement batteries.
11. Do not allow the batteries to become fully discharged; it may not be possible to re-charge them.
Batteries should not be discharged below 9.5 volts with 10 amps flowing.
12. Do not allow one battery to be discharged separately to the other.
13. Do not mix batteries from different machines.
14. The batteries fitted to this product are Valve Regulated Lead Acid (VRLA) gel electrolyte type.
The fitting of any other type of battery may cause a safety hazard.
Battery Care
1.
Always re-charge the batteries after use. This can be done at any time its not necessary to wait until they are fully discharged;
they do not develop a "memory".
2.
Leaving the charger to operate for a minimum of 4 hours after the green light has come on, at least weekly, will prolong battery life.
3.
Do not store the machine with the batteries discharged.
Daily
Keep the machine clean.
Ensure brushes/ pads/ squeegee/ filters are in good condition.
Check for any worn or damaged parts and replace immediately.
Drain and rinse dirty water tank after every use.
Store machine with brush deck secured in tilted position.
Weekly – as daily and –
Check brush or pad and skirt and rinse.
Check floor tool blades for wear and wipe clean.
Clean separator assembly including filter and check condition of seal.
Flush out system with clean water and clean filters.
Do not steam clean or pressure wash.
Batteries
Always re-charge the batteries after use.
Charge for a minimum of 4 hours after the green light has come on, this will prolong battery life.
Battery Model
Sonnenschein
MK Battery
HGB3045/55, HBG3045/55, TGB3045/55
TGB4045/100, TGB4055/100.
20
www.numatic.co.uk
Information for Scrubber Dryer
Battery Weight
18.48 Kg
31.8 Kg
TGB4055/100T
Battery Dimensions
278mm x 175mm x 190mm
327.5mm x 169mm x 218mm
Schematic Diagram
Advertisement
Table of Contents
