Table of Contents
Advertisement
MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
18
Maintenance
Cleaning - Unplug the device before cleaning. Generally, using a dry cloth for cleaning is
sufficient, but a moist, fluff-free cloth may also be used. Do not use liquid cleaners or aerosol
cleaners.
No User-serviceable Parts
Except for the external wiper blade, the device contains no user-serviceable parts. Contact
your local Bosch service center for device maintenance and repair. In the event of failure, the
device should be removed from site for repair.
On-Site Inspection
It is recommended that the device be inspected on-site every six months to check mounting
bolts for tightness, security, and any signs of physical damage. Inspection of this device shall
only be carried out by suitably-trained personnel in accordance with the applicable code of
practice (for example, EN 60097-17).
Information about cameras with illuminators
The text in this section applies only to cameras which have the optional illuminator accessory.
When servicing the device, disconnect power to the device to avoid possible exposure to the
eyes. If disconnecting power to the device is not possible, use appropriate shielding to block
the LED arrays or wear appropriate eye protection.
Illuminator removal
If you must remove the illuminator because it is damaged or has failed, follow these steps:
1.
2.
3.
Bosch Security Systems, Inc.
Remove the three (3) M4 Torx screws.
Install the access plug (which may be stored in an access hole of the MIC DCA or the wall
mount accessory; if not, see the note below.)
Note: If you do not have an access plug, do not remove the illuminator until you request
and receive a new access plug from Bosch.
Operation Manual
Maintenance | en
103
2014.05 | 1.0 | F.01U.291.520
Advertisement
Table of Contents
