Table of Contents
Advertisement
Editing All Patterns
e
Use
to align the needle and the mark on the
fabric, and begin embroidering the pattern.
Embroidering linked characters
Follow the procedure described below to embroider linked
characters in a single row when the entire pattern extends
beyond the embroidery frame.
Example: Linking "GHIJK" to the characters "ABCDEF"
using embroidery frame 18 cm × 13 cm (7 inches ×
5 inches)
*
The characters will be embroidered rotated by 90
degrees.
Memo
• When using the extra large (multi-position)
embroidery frame, align the top installation
position with the two pins on the embroidery
frame holder, and then press the frame down until
it snaps into place.
1 Top installation position
E-16
a
Select the character patterns for "ABCDEF", and then
press
and
.
Note
• After entering the "ABCD" when the "E" is
selected, a message appears and you need to
select the
to rotate 90 degrees to the right
before continuing with the "EF".
The message may appear before you enter the
"ABCD". The number of characters differs
depending on the type of the selected font.
• For details on selecting character patterns, refer
to "Selecting character patterns" on page E-2.
b
Press
.
c
Press
, and then press
→ The needle is positioned in the lower-left corner of
the pattern. The embroidery frame moves so that the
needle is positioned correctly.
Note
• To cancel the starting point setting and return
the starting point to the center of the pattern,
press
.
• Use
to select a different starting point for
embroidering.
d
Press
.
e
Lower the embroidery foot and then press the
"Start/Stop" button to begin embroidering.
.
Advertisement
Table of Contents
Troubleshooting
