Table of Contents
Advertisement
When installing the EcoKnight™ on a C
including the flue temperature sensor.
If the flue temperature sensor is not fitted, the flue gas temperature may exceed the maximum
temperature rating of the flue and can lead to severe personal injury, death or substantial
property damage.
To install a Type C
terminal or air inlet, the procedure for either a Type C
53
terminal should be followed noting that the annular space of the terminal should be sealed off.
10.17
TYPE B
(CONVENTIONAL FLUE WITH FAN ASSISTANCE)
23
When the water heater is installed as a Type B
flue manufacturer's specific instructions.
10.17.1
TYPICAL CONVENTIONAL FLUE ARRANGEMENT
A kit of components to facilitate conventional flueing of the appliance is available from Lochinvar Limited and must be
fitted prior to fitting any other flue components.
1.
Insert the exhaust transition into the exhaust port of the water heater.
2.
Insert the flue temperature sensor into the location hole on the exhaust transition.
If the flue temperature sensor is not fitted, the flue gas may exceed the maximum temperature
rating of the flue and can lead to severe personal injury, death or substantial property damage.
3.
Insert the air intake into the intake connection and tighten the worm drive clip.
4.
Insert the air inlet grill into the air inlet transition. For safety reasons this must be fitted prior to operating the
appliance.
twin pipe flue system, the Lochinvar Twin pipe flue kit must be fitted first
53
appliance, the flue system should be installed in accordance with the
23
(horizontal) or a Type C
13
(vertical)
33
39
Advertisement
Table of Contents
